If you have a single door which doesn t lock unlock you most likely have a problem with the actuator motor.
09 535i rear door lock inop.
11 ltz rjt v6 a6 in flood at 44k miles.
To lock the doors the bcm gets a true ground.
The door lock fuse is at the top.
Push down the clip to loosen the rod then pull the rod up and out of the door.
The door lock switches use a supplied ground to send a signal to the bcm.
The first time i noticed it was when i needed to get in that door.
I could be walking away and it locks.
It will not work with the key fob or with the door lock unlock controls on the front doors.
The vehicle will lock itself randomly regardless if the keyfob is in the vehicle or not or even near it.
The driver s side door lock switch does not work lock or unlock.
Unbolt the door lock assembly from the door and then pull the assembly out.
Push down the plastic clip on the door handle rod.
In order to remove the door panel.
09 2lt black granite metallic v6 a6 at 20 058 miles lost.
I can opening or closing the rear door and it locks.
The modern conveniences of vehicles are often lost upon drivers today.
When this is the problem you will need to remove the door panel and have a look.
Why door lock failure occurs in a bmw 26 mar 18.
Single door fails to lock unlock.
My 2014 double cab rear passenger door started doing this a couple weeks ago.
To unlock them it gets a signal through a resistor going to ground.
The engine is always off.
First unhook the negative battery power.
It was stuck in the locked position.
Reverse the process when you install the new door lock assembly.